In this study, Mo-14Si-10B and Mo-57Si-10B (at%) elemental powders were separately milled using an attritor mill.Mechanically alloyed powders were Nebraska agglomerated and annealed.Then, powders of Mo-Si-B as alloyed (with composites) and agglomerated (without composites) were plasma sprayed onto plain carbon steels.The samples, both coated and no
Sheila Z Jalalat, Richard F Wagner Jr Department of Dermatology, University of Texas Medical Branch, Galveston, TX, USA Abstract: The open access University of Texas Dermatology Interest Group blog was established in 2004 for the purposes of increasing communication and collaboration between medical students and dermatology faculty, residents, and
A solution of the vibration attention problem on a flexible structure from a dynamic vibration absorption perspective is experimentally and numerically studied in this article.Linear and nonlinear dynamic vibration absorbers are properly implemented on a primary structure of n Dishwasher Cup Rack degrees of freedom through a modal decomposition ana
Preparing and pre-testing experimental WINTERGREEN TOOTHPASTE setups for flight tests is a lengthy but necessary task.One part of this preparation is comparing newly available measurement technology with proven setups.In our case, we wanted to compare acoustic Micro-Electro-Mechanical Systems (MEMS) to large and proven surface-mounted condenser mic
Achieving research reproducibility is a precarious aspect of scientific practice.However, many studies across disciplines fail to be fully reproduced due to inadequate dissemination methods.Traditional publication practices often fail to provide a comprehensive description of the research context and procedures, hindering reproducibility.To address